The presence of FTA transponders on the Measat 3 Ku Band satellite makes many tragedy satellite trackers combine providers identified as Garmedia with Ninmedia. There is no mistake that many of these 2 satellite tracking tracker, because in addition to increasing the channel also the distance between the two satellites is quite close. That is why it is very possible, even relatively easy to make Ninmedia and Garmedia a plate together.
Not to mention in Ninmedia there is a new transponder since August 17, 2018 which makes the number of channels increase and the variety of broadcasts increases.
How to track Ninmedia and Garmedia in one dish
First, make sure you have expertise or understanding of tracking. Do tracking satellite Chinasat 11 or Ninmedia. Make Ninmedia its main focus, because this is much easier. Make sure you have locked all the Chinasat 11 transponders.
After Ninmedia has been locked, now it's just a move to measure Measat 3. Insert Garmedia 12436 H 31000 transponders or other transponders such as Transvision or K-Vision whose signal is strong throughout the territory of Indonesia.
Prepare a second KU LNB and attach it to the receiver, but don't use diseqc first. Why? to avoid interference from other ports or anticipate weak / corrupted diseqc.
Position this second LNB above the Ninmedia LNB with a slightly crooked position to the north (tracking location south of the equator, Lampung, Java, Bali etc.). The distance is between 1-15 cm, depending on the tracking location. Move this Measat 3 LNB while monitoring SQ (Signal Quality) in the receiver.
Ninmedia which is on the
Chinasat 11 satellite at 98o E coordinates is very close to Measat 3 (3 / 3A / 3B) at coordinates 91.5oE. Previously Measat 3 only contained transponders from K-Vision, Transvision, and Astro Astro, all of which were randomized and had to be opened by subscription.
Combining Ninmedia and Measat 3
To be able to combine the broadcasts of Chinasat 11 and Measat channels in 1 dish satellite dish can be done very easily. With only 2 pieces of KU-band LNBs, mini satellite dish, diseqc switch, and of course a little patience and creativity.
After getting the maximum Measat signal, keep in mind the position and distance of the LNB then bracket the LNB holder. This LNB bracket can be made using an iron plate / tin, iron elbow, a rather stiff wire or other equipment that is possible. Depending on each creation.
When the LNB holder bracket is ready, just attach the LNB to the satellite dish using the bracket that was made. Tighten it with ties or tied wire, and make sure the position is strong. Also make sure the signal quality is still strong. Don't forget to scan or blind scan to get the TV broadcast.
Post a Comment